clockworx wrote:
Any suggestions for a SC9800 player that is stuck in a reboot loop? I turned mine on one day (Cube H900HD), and it just sat at the boot logo for a bit, then rebooted, went to boot logo, rebooted, over and over. I can't really do much troubleshooting with USB since it reboots after about 45 seconds, even when plugged in.
Hello to all folks out there. Actually my V8000HDW got stuck in a reboot loop. It would show the white ainol boot again... and 30 seconds later go black... and then show the white ainol boot screen again. When plugging into the usb my PC did not see it at all. BAD NEWS.
Fortunately this thread saved the day. The Steps taken were to load the update software and load the firmware image. Try to update (and then get the can't find hardware message box). Turn off the player... hold down Esc (count to 3)... hold down power (count to 3)... press power quickly 3 times... let go of esc... and plug into the USB cable.
Since my player was foobar'd I decided to do a full erase when it asked... and just re-upped the firmware. Worked like a charm! Thanks to the poet for this very helpful and PMP saving thread.